nathan
12-16-2008, 11:24 PM
When creating a new device, the "Defaults" from the Administration/Other page for test rediscovery are taken, including the application profiles to use.
When Editing a test, either in the BVE or the GUI however, if you turn off rediscover and then turn it back on, the defaults are not taken.
This is a big issue because I have 100 devices and want to modify most of them to have the same settings, including application profiles.
There should be a way in the BVE to select application profiles when enabling rediscovery, OR just have the system take the defaults when turning discovery off and on in the BVE. This would save me hours...
When Editing a test, either in the BVE or the GUI however, if you turn off rediscover and then turn it back on, the defaults are not taken.
This is a big issue because I have 100 devices and want to modify most of them to have the same settings, including application profiles.
There should be a way in the BVE to select application profiles when enabling rediscovery, OR just have the system take the defaults when turning discovery off and on in the BVE. This would save me hours...